User guide
Link to Table of Contents
User Guide
36
User Manual
VLS3.60, VLS4.60 and VLS6.60 DIAGNOSTICS TAB
The Diagnostics Tab displays important information about your laser system and personal computer. This information
can be used for troubleshooting purposes.
ENGRAVER shows the current Firmware and FPGA version being used. It also displays the Serial Number of •
your laser system. The Serial Number is needed when calling the Customer Service Department at ULS.
SOFTWARE displays the current Materials Database, Language Database and Printer Settings Library versions •
being used.
OTHER DEVICES displays the current rmware version for the devices listed.•
LASER displays the watts being produced by the laser cartridge. It also displays the current version rmware •
being used. If a red ‘x’ appears, this indicates that the laser tube is not functioning properly or a door is opened
on the laser system.
If you press the Test button under USB LATENCY, it displays the time it takes for information to travel on the •
USB cable. Avg USB should be below 10 msec and Max USB should be below 100 msec.
SYSTEM displays information about your personal computer.•
ALARMS alerts you if the inside of the laser system is above the recommended temperature or if the Thermal •
Sensor battery is low in power. If the Thermal Sensor inside the laser system is triggered, an alarm will sound
and shut down your laser system.
FIXTURES indicates if a Engraving Table, Cutting Table or Rotary is installed and properly communicating.•
INTERLOCKS shows you if the Top, Front or Rear Doors are opened or closed.•
COMPRESSOR displays the current device being used, shown by a green check mark, to supply compressed air to •
the laser system. If a ULS compressor is connected, it will show the current rmware version.
The RUNTIME DIAGNOSTICS box is for ULS Engineering use only.•
The PRINT button gathers the information displayed on the Diagnostics Tab into a PDF le. This PDF le can be •
emailed to the Customer Service Department for troubleshooting.