Specifications

MEASUREMENT PROGRAMS
D525
D600
D630
D650
D660
D670
D800
X
X
X
X
X
X
D505D450
Half-Circle - Measurement values are taken in the 9, 6 and 3 o’clock positions.
Allows varying diameters. To be used with the Turbine system.
Center of circle PLUS - Versatile program with advanced functions. Measure-
ment points can be added, deleted or remeasured anytime during the measure-
ment. The reference line can be offset set. For use as described above.
Note! Display unit D279 can be upgraded and expanded with new software.
This means that above configurations is for standard systems.
XX
Flange - For measurement of flatness on flanges and circular planes, for
example axial bearings. Up to 150 measurement points can be handled.
Three zero points with 120° in between are calculated by the system.
Center of circle - This program is used when measuring the
straightness of bearing journals. Allows varying diameters.
Half-Circle PLUS - Versatile program with advanced functions. Measurement
points can be added, deleted or remeasured anytime during the measurement.
The reference line can be offset set. For use as described above.