User guide

56
3. Lower the laser system engraving table enough to install the rotary fixture. Make sure the motion system
will clear the top of the rotary fixture.
4. On the underside of the Rotary Fixture locate the self-aligning electrical connector (1) and two alignment
holes (2).
5. Insert the Rotary Fixture into the recessed slot (It is OK to do so with the power on because the rotary
fixture is hot swappable) and adjust until the connector engages, the alignment pins protrude through the
alignment holes in the base of the rotary fixture and the rotary is sitting flat. The rotary will indicate that it
is installed properly by automatically rotating its cone slightly. If you are using the rotary for the first time
or replaced the laser system’s CPU, rotary focus calibration may also be needed, if so proceed Rotary
Focus Calibration below. If rotary focus calibration is not needed the rotary is ready for use.