User guide

47
Installation
1. Remove (if present) the plug screw with a flat bladed screwdriver.
2. Using the provided 3/16 nut driver, attach the needle valve to the port from which you removed the plug.
Be careful not to cross-thread the small fitting when installing and do not over tighten it (the needle valve
will be left permanently installed on the carriage from this point forward).
3. Loosen the thumbscrew (1) on the side of the Focus Carriage (if already attached). Insert the cone (2)
into the cone base on the bottom of the Focus Carriage until it bottoms out and gently tighten the
thumbscrew.