User guide

10. Attach a power cord to the air filtration unit’s power inlet (5).

11. Connect the provided 3 ft. communications cable between one of the two Serial ports (2) of the laser

system and the Serial port connector on the air filtration unit (3). Secure the Serial cable using the

retainer clips (4).

12. Attach a power cord to the laser system’s power inlet (6).

13. Connect both air filtration and laser system power cords into a grounded outlet.

14. Connect the USB cable provided with the laser system between the USB port of the computer and the

USB port on the back of the laser system.

CAUTION: The laser system is USB 2.0 Hi-Speed (only). The laser system comes equipped with a high

quality, 6-ft (2.0 meter) USB 2.0 certified cable. We recommend you use this provided cable. Do not use

any adapters, extension cables, USB cables longer than 6 ft (2.0 meters) or other devices between the

computer’s USB port and the port on the laser system; sporadic or unpredictable behavior may result.