User guide

23
9. In some instances the laser must be installed in the laser system. If the laser is not already installed in the
laser system, locate the laser and follow these instructions to install it, otherwise skip to step 10.
a. Remove the back cover from the laser system by removing the two screws on the left and right
side of the cover.
b. Locate the two mounting blocks shown with arrows below and the laser connector on the left side
of the laser compartment.
c. Locate the “V” groove along the upper (3) and lower (2) part of the laser cartridge base plate and
the alignment plate (1) at the end of the base plate.