Troubleshooting guide

BASIC MAINTENANCE
Section 4-4
Y Guide Wheels
Figure 8
The Y Axis contains 4 wheels, 2 located on
top of the right Y Axis Rail and 2 below. To
properly clean the Y Axis wheels, you must
lower the Right Side Panel. 1
st
lower the
Rear Laser Cover by disengaging both
latches. Locate and remove both front and
rear 3/32” Button Head Screws (Fig 8). The
Right Side Panel is mounted using hinges,
slowly lower cover.
Press a Cotton Tip Applicator to the bearing
a slowly move the arm from top to bottom
until wheel makes at least 1 complete
revolution (Fig 9).
Figure 9
Figure 10
The only lubrication that may be required is the screw threads (Fig 10) for the table lifting mechanism.
After some time, contaminants can adhere to the lubricant, which can cause the engraving table to bind
up or sound squeaky. If this is the case, wipe off the contaminated grease with a soft cloth dampened
with alcohol and apply fresh white lithium grease to the screw threads. NEVER SPRAY ANY
DEGREASING SOLUTIONS DIRECTLY ONTO THE THREADS. Run the table up and down to work in
the fresh grease. Repeat if necessary.