Specifications

Section 2 - Installation
2.1 Unpacking and Assembling the Laser System
The laser system is shipped in one crate that contains the system, a cart with casters
and various accessories. The following steps outline the unpacking and assembly of
the system. Please follow these steps carefully.
IMPORTANT
Save the shipping crate. If the system must be
returned for service, it will have to be packed in its
original shipping crate.
1. Unscrew and remove the top portion of the crate. Reach inside and pull out the cart
panel which is located in front of the machine, packed between foam inserts.
2. Unscrew and remove the side panels. Remove the accessories box from the crate.
The accessories box is located underneath the laser systems fan enclosure.
3. Remove the cart legs from underneath the laser system. It is not necessary to lift
the machine at this time. The legs should slide out easily.
4. Open the accessories box and remove the four black casters and the bag of
hardware. The hardware bag should contain the following:
(6) 10-32 Allen head screws
(6) #10 lock washers
(4) 1/4-20 Allen head screws
(4) 1/4 " ID flat washers
(1) 5/32 inch Allen wrench
(1) 3/16 inch Allen wrench
(1) 3/4 inch open end wrench
5. Using the smaller Allen wrench, attach the two legs to the center panel with the six
10-32 Allen head screws and #10 lock washers as shown on the next page.
6. Attach the four black casters to the cart by threading the casters into the nuts that
are welded onto the bottom of each leg. Tighten each caster in place with the 3/4
inch wrench. There are two locking and two non-locking casters provided. Make
sure when attaching the casters that the locking casters are installed on the front of
the cart. Refer to the diagram on the next page.
WARNING:
The laser system weighs about 170 lbs (77kg). DO NOT attempt to lift it
alone. Get assistance from one or two other people.
9