Specifications

Focus Lens Holder Assembly

7. Place the Focus Lens back into the Focus Lens Holder with the convex side facing

upwards. Installing the Focus Lens upside down will result in the engraving being

out of focus. Then install the other Nylon Spacer and the Retainer. Make sure

that the Focus Lens and the Nylon Spacers are properly aligned as the Retainer is

tightened down snugly. DO e Retain r. To make sure the

Focus Lens and Nylon Spac ctly, hold it next to your ear and

#2/#3

NOT

ser gged before performing this procedure.

Hold

redu

them

clean

old then the Mirror will need to be

Altho

prec

1. While holding the Mirror, remove the Thumbscrew and pull the Mirror away from it’s

holder. Be careful not to slide the Mirror across it’s Holder as it can scratch easily.

NOT over tighten th

ers are ins alled corre

shake it back and forth. If the Focus Lens rattles, check the Focus Lens and

Nylon Spacer alignment and re-adjust as necessary. A loose Focus Lens in it’s

Holder will cause the appearance of a double image when engraving.

8. To re-install the Focus Lens, place it back on to the Focus Carriage and tighten

the Thumbscrew. There are two screw holes located on the Focus Carriage. The

Thumbscrew can be installed into either hole, there is no difference except that

one is for left-handed people, and the other is for right-handed people.

Mirror Inspection and Cleaning (as necessary)

E: The following procedure refers to both the #2 and #3 Mirror. Remember, the

system MUST be turned OFF and unplula

Inspect the Mirrors by looking at their reflective surfaces through the hole in the Mirror

er for signs of debris. We recommend this method of inspection because it will

ce the likelihood of accidental damage from constantly removing and replacing

. If the surface is hazy or showing signs of debris, then it must be removed for

ing because it is not possible to clean the Mirror correctly while it is mounted to it’s

er. If the surface of the Mirror is not clearly visible, H

removed for inspection and possibly cleaning anyway.

n inspecting or cleaning the Mirrors by removal, remove them one at a time so W

they do not get mixed up. They appear identical, but sometimes there might be a very

slight difference between them which can lead to a slight laser beam misalignment.

ugh this is highly unlikely, remove and replace them one at a time just as a

aution.