Specifications

LEATHER
TYPE POWER SPEED PPI PASS DEPTH
LIGHT RASTER ENGRAVING 20 100 500 1 .001”
COMMENTS: Engrave unmasked.
TYPE POWER SPEED PPI PASS DEPTH
DEEP RASTER ENGRAVING 60 100 500 1 .010”
COM sked. D er eng g will re mas g to pr
moke damage.
TYPE POWER SPEED PPI PASS DEPTH
MENTS: Engrave unma eep ravin requi kin event
s
VECTOR ENGRAVING 500 1 .003” 5 4.0
COMMENTS: Engrave unmasked.
TYPE POWER SPEED PPI PASS DEPTH
VECTOR CUTTING 50 2.0 200 1 .1”
OMMENTS: Mask top surface and use a low PPI setting when cutting.C
with the laser . Simulated l gr ll als ut the results are not as
nice Engra tly the ace of the leather dark
Try engraving at a light power setting
rst. If the result is not deep enough the job can be run again over the same spot.
Experiment with different depths of engraving and note the results.
ADDITIONAL COMMENTS
eather is a very simple material to engrave and most types of leather engrave very well L
system eather en
vin igh
aves we
w urn
o, b
as with the real thing. g l ill t surf
brown giving it a high contrast in appearance.
fi
72