Specifications

DELRIN (SEAL PRESS)

TYPE POWER SPEED PPI PASS DEPTH

RASTER ENGRAVING 100 60 500 1 .015”

COMMENTS: Engraved unmasked.

TYPE POWER SPEED PPI PASS DEPTH

VECTOR CUTTING 75 2.4 200 1 .060”

COMMENTS: Unmasked. A low PPI setting is used to prevent flaming.

ADDITIONAL COMMENTS

Making a seal using plastic is revolutionizing the industry. The laser can engrave and

ut out a typical Notary Seal in less than 5 minutes. A male and female die must be c

made as the diagram below indicates.

Seal Sample

Create the male with a white graphic and a black background. Mirror the image and

invert it by making the background white and the graphic black. Add a .010 inch black

outline to the graphic portion of the female side. This will give the greater clearance to

the female side to prevent the paper from piercing through when the male side of the

seal presses into the female side. Once the seal is made and fastened to the press,

make several impressions onto 400 grit sandpaper to smoothen out the edges of the

plastic. Make sure you turn the sandpaper over to get both sides of the seal.