Specifications

CORIAN or AVONITE
TYPE POWER SPEED PPI PASS DEPTH
RASTER ENGRAVING 100 70 500 1 .005”
COMMENTS: Mask first before engraving if planning to paint fill.
TYPE POWER SPEED PPI PASS DEPTH
DEEP RASTER ENGRAVING 100 35 500 1 .015”
COM nning to int fill.
TYPE POWER SPEED PPI PASS DEPTH
MENTS: Mask first if pla pa
VECTOR ENGRAVING 500 1 .010” 50 4.0
COMMENTS: Mask first if planning to paint fill.
ADDITIONAL COMMENTS
Laser engraving this type of material produces spectacular results especially when the
engraved area is paint filled. If paint filling, it is a good idea to mask first and then
engrave through the masking. In this way, when ready to paint fill, the material is
already masked. Spray painting seems to be the easiest. Using a paint brush is
acceptable but time consuming. Use the paint sparingly. Excess paint can accumulate
on the edges of the engraving which will make mask removal difficult and leave
unsightly ridges. It is best to apply several lighter coats than one heavy coat of paint.
Remove the masking after the paint has dried. Engraving this material without paint
filling can work but most of the time there is very little contrast which makes the
engraved area difficult to see.
68