Specifications

ACRYLIC - CAST AND EXTRUDED

TYPE POWER SPEED PPI PASS DEPTH

LIGHT RASTER ENGRAVING 25 100 500 1 .001”

COMMENTS:

Remove original factory masking from the engraving surface. Leave the masking on the

non-engraved surface to prevent accidental scratches.

TYPE POWER SPEED PPI PASS DEPTH

DEEP RASTER ENGRAVING 100 70 500 1 .010”

COMMENTS:

This sample engraved deeper than the first sample. Engrave through original masking.

TYPE POWER PASS DEPTH

Engraving too deep will lose detail.

SPEED PPI

VECTOR ENGRAVI 1 .2” NG 500 5 4.0

COMMENTS:

Engrave with or without masking

TYPE PO ED PPI PASS DEPTH

WER SPE

VECTOR CUTTING 7 500 1 .2” 5 .8

COMMENTS:

For the best results, remove the original masking on both sides. Re-mask with transfer

tape. Moisten both sides with Elevate the material at least

1/8” off of the engraving table.

water from a spray bottle.