Specifications

4. Position the graphic, on screen, so that it will fit vertically within the new page

height and horizontally within the engraving area of the glass. If the graphic does

not fit within the vertical page size limits, the portion that is outside the page limit will

not engrave. Remember, the new page size that the driver calculates from the

diameter of the glass is it’s actual circumference. From the top of the page down to

the bottom is one complete revolution of the glass. Since the Rotary Fixture will not

turn more than 360 degrees, make sure that the graphic lies between the page

limits.

5. If you will be engraving something that is not cylindrical such as a mug with a

handle, or the engraving needs to put in a certain location on the glass proceed to

the next step otherwise proceed to Step 10.

Or you

, between the top

of the page and the vertical center of the page. If you would like the graphic on the

other side of the mug, position the graphic, on screen, centered between the

vertical center of the page and the bottom of the page.

6. Let’s use a mug with a handle as an example. Place the mug into the Rotary Fixture

and lock it down. Make sure that the motion system is in it’s home position by

pressing the “PAUSE” button. By hand, rotate the mug until the handle points

straight up. You can accomplish this by releasing the locking mechanism, rotating

the mug until the handle is pointing straight up, and locking it back down.

can simply rotate the mug while it is locked down by turning it until the handle points

straight up. It is no problem to do this even if you turn the cone of the Rotary

Fixture. The laser system will use whatever position the Rotary Fixture is resting at

as it’s home position when it starts to engrave the file.

The Rotary Fixture rotates towards the back of the laser system as is starts to

engrave. If the graphic extends from the top of the page (on screen) to the bottom,

the Rotary Fixture will rotate 360 degrees until the handle comes to a stop,

positioned straight up making one complete revolution.

If you would like the engraving positioned opposite the handle (180 degrees), place

the graphic, on screen, centered between the top of the page and the bottom of the

page. If you would like the engraving positioned between the handle and 180

degrees opposite the handle, then center the graphic, on screen