Specifications

The “RETAIN SETTINGS” submenu

Then

By selecting “RETAIN SETTINGS”, any and all changes made to the display settings

will be permanently stored even if power is turned off to the laser system. Those

ettings will be retained in the laser system until they are changed and “RETAIN

he Process Controls

SETTINGS” is selected again.

Process Controls

START

The “START” button runs the current job displayed.

AUSE AND RESUME

e “NEXT JOB” button brings up the next job in the system buffer and makes

the current job. This button is inoperative if a job is currently running.

If a job is running, the “PAUSE” button halts the engraving or cutting process. When

paused, the motion system arm will move to its home position in the upper right corner

of the engraving area. When ready to continue operation, press the “RESUME” button

and the system will begin cutting or engraving again where it left off. If you wish to run

the file from the beginning after pressing the “PAUSE” button, press the “START”

button.

NEXT JOB

Pressing th