Specifications

The “LOAD DEFAULTS” selection on the last line resets the laser systems

motherboard to its originally manufactured settings. Settings such as “TICKLE” and

“SET ROTARY AXIS” will NOT be restored to the same settings that were in the laser

ystem when you first received it. Chances are, these two settings were altered by the

production department before the laser system was shipped. “LOAD DEFAULTS’

nullifies those settings made by our production department. If you inadvertently made

this adjustment, you will need to reset the Tickle and the Rotary Axis adjustments.

The “DIAGNOSTICS” submenu

The “DIAGNOSTICS” selection allows the testing of certain features of the engraving

ystem. Selecting this option will lead to other submenus.

The “TEST MEMORY” submenu

Then

It may be necessary to use the diagnostic tests if instructed to do so by a member of our

technical support staff. The “MEMORY TEST” is a buffer memory test to test the RAM

the laser system. This is very similar to the RAM test that your computer performs

process of testing memory, all jobs in the buffer

TEST” is started it will continue to run until it is

anceled. To start the test select “YES (CLEARS THE BUFFER)”. To end the test,

select “CANCEL”. This test will continuously pass through the memory. If it finds

memory that is bad, it will show up as a failure and the SIMM module will need to be

replaced.

The second line of the “TEST MEMORY” submenu displays the current position of the

motion system in motion system units (thousandths of an inch). Each unit represents a

single step of the motion system motors. The final two lines are a copyright notice and

the current version numbers of the OROM (Output Read Only Memory) and the

IROM(Input Read Only Memory).

when it first gets powered on. In the

will be erased. Once the “MEMORY