Specifications
Now, select the “YES SAVE Y AXIS” choice. If you change your mind and do not wish
to alter the “ROTARY AXIS” position, select “CANCEL” instead and the original settings
will be restored.
NOTE: To save this setting in the laser systems memory configuration, “RETAIN
SETTINGS” must be performed. This procedure is defined later in this section. If you
do not “RETAIN SETTINGS”, all changes that you made, even after selecting “YES
SAVE Y AXIS”, will be lost and the previous settings will remain.
To restore the Rotary Fixture back into it’s original factory condition, locate the Rotary
Fixture in it’s normal position and repeat this entire procedure.
The “ALIGNMENT MODE” submenu
Then
This submenu allows access to firing the laser beam to determine if the laser systems
optical alignment is correct. DO NOT attempt adjustment unless you have had proper
training from Universal Laser Systems Inc. If you are experiencing trouble with the laser
system and cannot resolve the problem, please call our technical support.
The “LOAD DEFAULTS” submenu
Then
48