Specifications

too high, reduce the Rate setting, while observing the file as it is running, until the

shadows disappear. If the Rate setting gets down to zero and the shadows are still

present, then put the Rate back to its original number and reduce the Width by one. If

the shadows still appear, keep reducing the Rate again until it does disappear. If the

setting is too low, increase the Rate setting until the shadows appear, then back it off

one or two numbers. Once the Tickle is set properly, escape out of the menu and

“Retain Settings” which will make the changes permanent.

The “CONFIGURATION” submenu

The “CONFIGURATION” submenu allows the reconfiguration of certain features of the

engraving system. Selecting this option will lead to other menu choices.

The “PORTS” submenu

Two ports are provided on the right side of the system for interface with a computer, a

serial and a parallel port. Only one port can be used at a time. To activate a port,

select “PORTS” from this menu and one of the following submenus will appear:

The menu that appears indicates the currently active port on the laser system. To

switch to the other port press the “SELECT” button. In order to use the “SERIAL” port,

the communication settings MUST match those of the computer. Refer to the

computer’s hardware and software manuals for details on setting up the computer’s

serial port.