Specifications

8. Using the larger Allen wrench, attach the system to the cart using the four 1/4-20

Allen head screws and flat washers. The screws pass through the cart legs and into

the bottom of the system as shown.

9. Once all of the screws are tight, adjust the thin nut on each of the casters so that all

four wheels are touching the ground evenly. If desired, use a level gauge placed on

the engraving table and adjust the casters until the laser system is completely level.

Once level, tighten the thicker nut on the casters upwards against the bottom of the

leg frame to lock in this adjustment.

2.2 Operating Environment

Before the system is installed, choose a suitable location. Follow these guidelines:

 Avoid places where the system may be exposed to high

temperatures, dust, or high humidity (humidity exceeding

70% or where the temperature is near the dewpoint). The

laser system should be installed in an office type environment.

 Avoid places where the system may be exposed to high levels

of vibration or electrical noise. We recommend using a high

quality surge protector to protect the laser engraving system's

electronics.

 Avoid small enclosed areas where ventilation is poor.

 Choose a place where the ambient operating temperature will

remain between 60 and 80 degrees Fahrenheit or between 15

and 25 degrees Celsius.

 Choose a place which provides a short and direct path to the

exhaust duct work (not provided).

 If planning to connect the laser engraving system to a

computer through the parallel port, choose a location where

the computer can be placed within 10 feet of the machine

since this is the maximum recommended parallel cable length.

 If planning to have another laser system or other type of

printer connected to the same computer, we recommend

installing an additional parallel port into the computer system.

DO NOT use a manual A/B type switch box. This creates

electrical noise which can cause an engraving problem or can

damage the laser system’s electronics.

 Try to have a work table or storage area next to or nearby the

laser system. This prevents the operator from using this

precision machine as a table or storage facility.