User manual

33
Running Your First Job
Step 4 – Starting the Process
Turn on the exhaust and VersaLASER system.1.
CAUTION: Observe that the laser system is functioning as desired. If any abnormalities occur,
including, but not limited to, aming, sparking, melting or excessive smoking of the material
you are engraving, stop the engraving process immediately by either pressing the pause
button or opening the top door. Re-check the settings in the printer driver as well as the laser
system. If everything seems to be correct, check focus manually as described in the User
Manual located in the Reference Guide packet and adjust if necessary. If you cannot resolve the
issue, please contact your distributor or the ULS Customer Service Team. Never leave the laser
system unattended during the engraving or cutting process.
Step 5 – Material Removal and Reloading
Once the laser system has completed processing the material, the laser beam will turn o and
the focus carriage will move to the home position in the upper right hand corner.
Before opening the top door, wait a few seconds to allow any remaining fumes that are leftover
from the laser engraving or cutting process to evacuate through the exhaust system.
Congratulations! You have just completed your rst engraving project with your new VersaLASER
system.
Make sure the material is positioned correctly within the engraving area.2.
Close the top door.3.
Click the green START button on the UCP to begin laser processing (Figure 6 on previous 4.
page).
Note: Laser system cooling fans are variable speed and may speed up and slow down
during operation as needed to cool the lasers.