User manual

29
Assembling Your VersaLASER System
Checking Beam Alignment
Note: You will not engrave anything at this time.
Open the top door.1.
Place a small piece of masking tape across the 3/4” hole in the focus carriage (1). Gently rub 2.
the tape around the edge of the hole so that you can see the outline of the hole through the
tape (2) .
Power on your computer and verify that the Universal Control Panel (UCP) icon is present on the 3.
taskbar. If not, activate it by double-clicking on the “Universal Control Panel” icon on your
desktop.
Power on the laser system by pressing the Power Button 4. on the VersaLASER system
With the top door open, a red dot will appear on the masking tape (3). The red dot should 5.
appear centered, within 1/8 inch. If not, turn o the laser system, remove and re-install the
laser cartridge and try again. If the red dot still does not appear centered, please contact our
Customer Service Department at 480-609-0297 (USA), [phone] (Austria),
[phone] (Japan) or e-mail us at [e-mail].
Laser beam alignment is now complete. Power o the laser system and 6. remove the masking
tape.
Focus Carriage Beam Alignment
keypad.