User manual

25
Assembling Your VersaLASER System
Finalizing the Connections
Make the following connections in the order described, otherwise static electricity can potentially
damage the computer and/or the laser systems electronics.
Connect the 4-inch exible rubber exhaust system to the rear of the laser system if you have 1.
not already done so.
Connect the laser system’s power cord and your computer’s power cord to a grounded electrical 2.
outlet.
Note: A properly installed 9-volt battery is necessary to operate the laser system. The laser
system will not function without a charged battery installed. Keep a spare 9-volt battery on hand
at all times.
Do not power on the laser system at this time.3.
Install the provided 9-volt Thermal Sensor battery into the VersaLASER system.4.
Gently push up on the Thermal Sensor battery holder drawer as indicated. Pull the battery a.
holder drawer out.
CAUTION: Make sure that you attach the adapter correctly to the power cord and that your
power source is properly grounded (Earthed).
Insert the 9-volt battery provided into the battery holder drawer.b.
Reinsert the battery holder drawer into the cavity until it latches in place.c.
Note: International users may need to connect an adapter to the power cord to be able to plug
it into their power source.