User manual

20
Installation & Set-up Guide
Plug in the power connector (1). Close the rear cover, making sure that wires or hoses do not 6.
become pinched when the cover is closed. Gently close the rear cover until the sliding latches
lock into place.
Once the laser cartridge has been installed, proceed to 7. “Laser System Leveling” on page 21.
Slowly rotate the laser cartridge, making sure that the alignment plate is centered in the 5.
gap in the alignment fork. As you slowly release the weight of the laser, you should feel
it lock itself smoothly into place. Never force the laser into position. If the laser does not
install smoothly, check for obstructions such as pinched wires or hoses or a binding laser latch.
Once installed, verify that the alignment plate is centered within the alignment fork.