User manual

19
Assembling Your VersaLASER System
Observe the “V” groove along the upper (3) and lower (2) part of the laser cartridge base plate 3.
and the alignment plate (1) at the end of the base plate.
Pick up the laser cartridge by the ends and tilt it at a 30 degree angle as shown (1). Mount the 4.
cartridge onto the mounting blocks shown in step 2 (page 18) by placing the upper “V” groove on
top of the mounting blocks. Slide the cartridge to the right until the outer edge (2) of the
alignment plate contacts the inside edge of the large plate of the alignment fork.