User manual

18
Installation & Set-up Guide
Laser Cartridge Installation
Make sure that your power cord to the system is not plugged in at this time. Place your nger 1.
in the slotted hole and gently pull back on both sliding latches. Gently fold back the rear cover.
Visually locate the two mounting blocks (1), the laser latch (2), alignment fork (3) and power 2.
connector (7). Notice that the alignment fork has two plates, one small (4) and one large (5).
Locate the gap between the two plates (6).
Note: Access latches for the laser cover are lockable. However, all systems are shipped from
the factory with latches unlocked. If you need to lock the latches please contact our
Customer Service Team at 480-609-0297 (USA), [phone] (Austria), [phone] (Ja-
pan) or e-mail us at [e-mail] for keys.