User manual

17
Assembling Your VersaLASER System
System Assembly - VersaLASER VLS6.60 System
Detaching laser system from cart to t through small doors (Optional)
Remove any packing materials or accessories inside the laser system.1.
Using strong shipping tape or rope, tape the top and front door closed so that they do not 2.
open up when tilted.
Remove the eight screws that attach the cart stand to the laser system from the bottom (See 3.
below.)
Lift the laser system straight up.4.
Place the laser system front door down on a dolly and roll it through the doorway. Lift and 5.
rotate the cart to move it through the doorway.
Carefully line up the laser system and place it back on top of the cart stand. 6. Be careful not
to pinch your ngers.
Reassemble the laser system and 7. proceed to “Laser Cartridge Installation” on page 18.
Unpack the laser system from its packaging.1.
Place the laser system in the desired location for operation.2.
If a doorway is not wide enough to pass the laser system through, the system can be a.
detached from the cart stand and carried through the door on it’s side.
If you do not need to detach the laser system from the cart to move it to the desired location b.
for operation, you can proceed to “Laser Cartridge Installation” on page 18.