User manual

15
Assembling Your VersaLASER System
Assembling Your VersaLASER System
System Assembly - VersaLASER VLS3.60 and VLS4.60 Systems
Depending on which model VersaLASER system you have purchased, assembly of your laser system may be
required. Once the system has been assembled, it is necessary to install the laser cartridge on the back
of the machine and perform a beam alignment check. Do not power up your laser system until the nal
step, “Checking Beam Alignment.”
CAUTION: Do not attempt to move or lift this system alone. Obtain assistance from three or four
additional people when lifting or carrying (secure motion system and doors before lifting). Bodily
injury may occur if improper lifting techniques are used or the system is dropped.
4
1
2
2
3
3
4
5
6
5
5
7
7
7
7
Back panel1.
Legs (both are identical)2.
Nuts (4)3.
Locking casters (4 are identical)4.
1/4-20 x ½, socket head screws 5.
w/lock & at washers (8)
10-32 x 3/8 socket head screws 6.
w/lock & at washers (2)
Connect to main enclosure7.
Cart Assembly
Unpack the laser system from its packaging.1.
Remove the unassembled cart from the top of the laser system.2.
Assemble the cart as it appears in the diagram below, but leave all of the screws slightly 3.
loose, except for the casters which should be tightened as far as possible into the cart leg.
System Assembly - VersaLASER VLS3.60 and VLS4.60 systems: Page 15
System Assembly - VersaLASER VLS6.60 system: Page 20
Familiarize yourself with the instructions before getting started.