User guide

Link to Table of Contents
User Guide
181
Maintenance
Exhaust Plenum
Power on the laser system and UCP.1.
Using the Z-Axis buttons on the laser system or UCP, raise the Z-Axis table as high as possible.2.
Power the system OFF.3.
Open the front door.4.
Locate and remove the two socket head cap screws found on the inside of the laser system.5.
Using both hands, reach in and grasp the exhaust plenum.6.
Lift the plenum straight up until the tabs (1) of the plenum clear the two at head screws (2) on which they 7.
are resting. Tilt the bottom of the plenum towards you and remove it from the system.
2
1
Note: The VLS6.60 exhaust plenums are removed in the same fashion, but is equipped with two exhaust
plenums.
Using the soap and water solution, clean the inside of the plenum as well as the inside rear wall of the laser 8.
system.
Installation is opposite of removal. Verify that the plenum tabs (1) rest on the two at head screws (2).9.