User guide

Link to Table of Contents
User Guide
60
User Manual
CAUTION: Do not attempt to use the vector-scaling feature when your graphic
extends out to the absolute edge of the engraving eld. You may accidentally cause
the driver to attempt to print past the edge of the maximum allowable page size.
Unexpected results may occur. If you use this feature, the actual allowable page
size decreases by the same amount that you are attempting to oset.
Engraving Field Sub-Tab
Units
Units allows you to change between Metric and
Inches.
Language
Select from many dierent languages in this drop
down list. Some language changes will not take
eect until the printer control panel is closed and
then re-opened.
Engraving Field
Width and Height
The page size that you enter in Width and Height must match the page size in your graphics software
program EXACTLY and it is up to the operator to enter in the correct settings. Select the metric box if
metric units are desired.
Note: Incorrect use of this feature may cause no graphics, partial graphics, erroneous graphics or
a misaligned graphics output relative to the application material to occur. To avoid problems,
we recommend that you set the Width and Height to the maximum eld size of your laser system
(click the Max Size button) and also set your graphics software programs page size to match.
Max Size Button
Clicking on the Max Size button restores the driver back to the default maximum page size that your
model can accept.
Rotary
This option is available for all models. Please refer to the Accessories section of this manual on how to
install and use the Rotary Fixture.
Diameter
The diameter of the cylindrical object being engraved will be entered in this eld.
Rotation Factor
If you have purchased the optional Rotary xture, you may need to calibrate your xture if your
application requires you to engrave or cut completely around the cylinder precisely 360 degrees. Only
use this option if you completely understand and have used the Rotary Fixture in the past. If you are
familiar with the operation of the Rotary Fixture and in your application you create a vector line or
raster graphic that extends from the top of the page (in your graphic software) all the way to the
bottom of the page, you should expect that the Rotary Fixture would rotate a full 360 degrees. If the
xture comes up short or long by a few degrees, you can compensate for this in the driver. If your
application comes up short, increase the number past 1.0000 as much as you need to and run your
sample again. If your application rotates past 360 degrees, then decrease the number of degrees
below 1.0000 to get the ends to line up. You can calculate the exact number (refer to the Vector
Scaling technique on the previous page), but it may be dicult to measure circumference.
Dual Head (PLS Only)
Dual Head is also an optional accessory. If you have purchased this option, please refer to the
ACCESSORIES section of the manual for more information.