User guide

Link to Table of Contents
User Guide
50
User Manual
Flow (Computer Controlled Air Assist only)
This feature will not appear if you do not have the Computer Controlled Air Assist option. If you do have Computer
Controlled Air Assist, but are not using it, you MUST leave the setting to OFF, otherwise your system will hesitate
up to 10 seconds after you press the start button on the machine. If you purchased the Computer Controlled Air
Assist option, please refer to the Accessories Guide for detailed instructions on how to use the printer driver controls
properly.
Set Button
Flow Rate
(Computer Controlled Air Assist only)
To control the Flow Rate of the Computer Controlled Air Assist accessory, select from the percentage rates available.
After making % Power, % Speed, PPI and any other adjustments for the Pen parameters, you must click the SET button
to register the changes. The changes will not be saved until the OK or APPLY buttons are clicked.
Default Button
Cancel Button
Apply Button
Load Button
Save Button
By clicking Save, the “Save Engraving Setup” dialog box will appear and will allow you to enter in a le name. All
settings will be stored in this le that has a “.LAS” extension. These les can be stored in any directory on your hard
drive and you can have as many setting les as your disk can hold. Verify that you have clicked the SET button before
you save any .LAS les to ensure you have properly saved your settings.
To recall printer driver settings that have been previously saved, click on the “Load” button and choose the desired
.LAS settings le. The settings that are currently on screen will be replaced by the settings from the .LAS le. You may
abort this change by clicking Cancel; clicking OK will approve the change.
The Default button will reset the driver settings to the original manufacturer values.
The Cancel button closes the printer driver window and takes you back to the previous window. If the SET, OK or
APPLY buttons were not clicked, the changes will not be saved by the Printer Driver.
The APPLY button saves all changes made to the Manual Control Tab. These changes include any modications made
to the Raster, Vector or Engraving Field sub-tabs.