User guide

Link to Table of Contents
User Guide
27
User Manual
Relocate View (drop down list)
The Relocate feature gives you the opportunity to move the image on the UCP into another area of the
engraving eld. This feature does not modify your original le’s image location.
When this feature is activated, the image is surrounded by nine small white squares (anchor points) allowing
you to move it around the basic view screen. The current anchor point selected, in blue, is the axis of movement.
If you would like to move the graphic back to its original location, click on the Undo button under the X and Y
cordinates until the grahic is in the desired location.
Relocation Types
You can click on any anchor point available to move the graphic within the basic view area.1.
If you would like to move the graphic to the upper left hand corner, select the top left hand anchor 2.
point and type in your desired X Y coordinates into the boxes that appear on the right hand side. This
process can be done with any available anchor point.
Using your Navigation buttons, move the focus carriage to the desired location where you would 3.
like the image to be placed. Use the red LED as a reference point. Click on the TO CARRIAGE button.
According to the anchor point you have selected, the image on the Relocate View will move to
the location of the focus carriage’s red LED.