User guide

Link to Table of Contents
User Guide
25
User Manual
Basic View (drop down list)
The Basic View shows a preview window of the job currently selected.•
The cursor becomes a magnifying glass (Zoom Tool) if you pass it over the preview window. Left-clicking the •
mouse zooms in and right-clicking zooms out.
Clicking the Settings button takes you back to the printer driver. If mistakes were made or you would like •
to make additional changes, clicking this button allows for those changes. Further information about the
printer driver can be found on page 39 of this guide.
Viewer Tab
System Controls
The green START button begins the engraving process.•
Clicking the PAUSE button stops the engraving process and clicking the PAUSE button again resumes the •
engraving process where it was last stopped.
The four Navigation buttons move the focus carriage back and forth or left and right.•
The two up and down buttons move the Z-Axis engraving table up or down.•
The Home XY button re-homes/moves the focus carriage to the upper right hand corner.•
The Home Z button re-homes/moves the Z-Axis table towards the bottom of the laser system.•