Setup guide

Universal Laser Systems VersaLASER VLS2.30 and VLS3.50 Installation and Setup Guide
Exhaust blower mounted outside* (User Supplied)1.
Weatherproof shield (User Supplied)2.
Rigid ducting matching the diameter of the blower inlet (User Supplied)3.
Shut-o or air- ow gate (User Supplied)4.
Adapter to the hose reduces from 4” to 3” (User Supplied)5.
Flexible, wire-reinforced, industrial grade rubber hose (User Supplied)6.
Connection to laser system7.
Exhaust On/O switch (User Supplied)8.
Computer (User Supplied)9.
1
2
3
4
5
6
7
8
9
VLS2.30 and VLS3.50
*Exhaust blower illustration my di er according to your region.
Note: The following diagram shows a typical exhaust system layout. Use this as a guideline for proper exhaust
system installation. Although this diagram serves as an example, we recommend you consult with a licensed
contractor to meet local safety, environmental and building code requirements and to also calculate the correct size
blower required for your particular installation. Length of exhaust pipe, exhaust pipe diameter, number of 90-degree
angles and other restrictions must be calculated when determining the correct exhaust blower unit. Installing an
undersized or oversized blower is not only unsafe, but can also lead to excessive wear and tear to the laser system
and premature failure.