Setup guide

Universal Laser Systems VersaLASER VLS2.30 and VLS3.50 Installation and Setup Guide
Step 4 – Starting the Process
Turn on the exhaust and VLS system.1.
CAUTION: Observe that the laser system is functioning as desired. If any abnormalities oc-
cur, including, but not limited to,  aming, sparking, melting or excessive smoking of the ma-
terial you are engraving, stop the engraving process immediately by either pressing the
pause button or opening the top door. Re-check the settings in the printer driver as well as
the laser system. If everything seems to be correct, check focus manually as described in the
User Manual located in the Reference Guide booklet and adjust if necessary. If you cannot re-
solve the issue, please contact your distributor or the ULS Customer Service. Never leave the
laser system unattended during the engraving or cutting process.
Step 5 – Material Removal and Reloading
Once the laser system has completed processing the material, the laser beam will turn o and the focus carriage
will move to the home position in the upper right hand corner.
Before opening the top door, wait a few seconds to allow any remaining fumes that are left over from the laser
engraving or cutting process to evacuate through the exhaust system.
Make sure the material is positioned correctly within the engraving area.2.
Close the top door.3.
Click the green START button on the UCP to begin laser processing (Figure 6 on previous page).4.
Note: Laser system cooling fans are variable speed and may speed up and slow down during operation
as needed to cool the lasers.
Congratulations! You have just completed your  rst engraving project with your new VLS system. Below is an
image of the sample engraving job. If your results are not satisfactory, please contact the Customer Service
Department at 480-609-0297 (USA), [phone] (Austria), [phone] (Japan) or e-mail us at support@
ulsinc.com.