Setup guide

Universal Laser Systems VersaLASER VLS2.30 and VLS3.50 Installation and Setup Guide
Running Your First Job
We will now illustrate how to use your laser system to engrave on a piece of anodized aluminum from start to
 nish. In this example, you will raster engrave a Test Card on a 2 x 3.5 inch (50.8 x 89 mm), 0.0195 inch (0.49 mm)
thick piece of anodized aluminum.
Note: For this example we will be using CorelDRAW X3 and the CorelDRAW sample  le provided on the software
CD. Install CorelDRAW, but do not start a new project.
Step 1 – Loading and Positioning the Material
Open the top door and position the piece of anodized aluminum (1) into the upper left corner of the table, against
the rulers.
Step 2 – Creating the Graphic
1
Using CorelDRAW, open the sample graphic  le found on the software installation CD that came with the VLS
system. The  le is named ULSTest.cdr. The Software Installation CD contains test  les in .cdr, .eps, and .dxf.