Setup guide

Universal Laser Systems VersaLASER VLS2.30 and VLS3.50 Installation and Setup Guide
Checking Beam Alignment
Note: You will not engrave anything at this time.
Open the top door.1.
Place a small piece of masking tape across the 3/4” (19 mm) hole in the focus carriage (1). Gently rub the tape 2.
around the edge of the hole so that you can see the outline of the hole through the tape (2).
Power on your computer and verify that the Universal Control Panel (UCP) icon is present on the taskbar. If not, 3.
activate it by double-clicking on the “Universal Control Panel” icon on your desktop.
Power on the laser system by pressing the Power button on the top of the VLS system.4.
With the top door open, a red dot will appear on the masking tape (3). The red dot should appear centered, within 5.
1/8 inch (3mm). If not, turn o the laser system, remove and re-install the laser cartridge and try again. If the
red dot still does not appear centered, please contact our Customer Service Department at 480-609-0297 (USA),
[phone] (Austria), [phone] (Japan) or e-mail us at [e-mail].
Laser beam alignment is now complete. Power o the laser system and 6. remove the masking tape.
Focus Carriage Beam Alignment