Setup guide

Universal Laser Systems VersaLASER VLS2.30 and VLS3.50 Installation and Setup Guide
Select “c. Install the software automatically.” Then Click “Next” to continue. You do not need to insert the
Software Installation CD-ROM.
A warning message will appear. Select “d. Continue Anyway.” Do not be concerned. Installing the ULS Firmware
will not harm your computer in any way. The  rmware will begin to load.
Click “e. Finish” to close the Wizard.
Another set of f. New Hardware Wizard windows may appear after the initial USB connection. Follow the same
instructions as mentioned previously. Once completed, your new hardware is installed and ready to use.
Once installed, g. proceed to page 214.