Installation Guide

"A"
3-1/2" (89 mm)
3/4" (19 mm)
12" (305 mm)
"B"
2-3/4"
(70 mm)
7/16" (11 mm)
2" (51 mm)
3/8" (9.5 mm)
1-1/2"
(38 mm)
C
L
of Hinge
HINGE OPPOSITE SIDE
FRAME
DOOR
FRAME
DOOR
PA
PLATE
Top View
Notes: Closer is shipped at 11 turns. Maximum of 26 turns of power
adjustment screw. Refer to Page 6, Fig. 5 to determine proper closer size.
1/2" (13 mm)
Door
Swing
Right Hand Door
Power
Adjustment
Left Hand Door
Power
Adjustment
Pinion Dimple
Pinion Dimple
MAIN ARM INSTALLATION INSTRUCTIONS
MODEL
DIMENISON "A" DIMENION "B"
OPENING
DOOR WIDTH
CLOSER
SIZE
# OF TURNS OF
POWER
ADJUSTMENT
SCREW
INCHES
[mm]
INCHES
[mm]
INTERIOR EXTERIOR
UH4061
UH4062
3-3/4"
95
9-1/2"
241
TO 120° UP TO 54" UP TO 42"
5
+13
4
+6
3 0
2
-5
1 -11
1-1/4"
32
7"
178
TO 180° UP TO 54" UP TO 42"
5
+13
4
+7
3 0
2
-4
-10
PAGE 5
PARALLEL ARM INSTALLATION
MODEL UH4061 or UH4062 INSTALLATION INSTRUCTIONS
999-30027
INSTALLATION SEQUENCE
1. Select degree of opening and use
dimensions shown to locate 4 holes
on door for closer body and 4 holes
underside of frame for PA plate.
2. Prepare door and frame for
fasteners (See Preparation for
Fasteners, Page 2, Figure 2).
3. Before installing closer body, set
spring power for closer using
Power Adjustment Chart below.
4. Install closer on push side of door with power adjustment valve
towards
the hinge.
5. Mount parallel arm plate to frame. Disassemble forearm from main
arm by removing forearm screw. Remove forearm shoe from forearm
and attach forearm to parallel plate with forearm screw (See Page 2,
Figure 1).
6. Mount main arm onto closer pinion shaft (See Main Arm Installation
Instructions) by preloading pinion 45° and align pinion dimple with
main arm marking. Secure with main arm screw.
7. Reassemble arm. Adjust forearm length so that main arm pivot is
1-1/2" (38mm) from closed door face.
8. Adjust closer (See page 6) and install cover.