Installation Guide

"A"
12" (305 mm)
3/4"
(19 mm)
5/8" (16 mm)
2-3/8"
(61 mm)
C
L
of Hinge
FOOT
FRAME
DOOR
HINGE OPPOSITE SIDE
Top View
Pinion Dimple
90°
Left Hand Door
90°
Main Arm
Preload
1 & 2
Valves
1 & 2
Valves
Door
Swing
Right Hand Door
Main Arm
Preload
PAGE 4
MODEL
DIMENISON "A"
OPENING
DOOR WIDTH
CLOSER
SIZE
CLOSER
SIZE
# OF TURNS OF
POWER
ADJUSTMENT
SCREW
# OF TURNS OF
POWER
ADJUSTMENT
SCREW
INCHES
[mm]
INTERIOR EXTERIOR
7-1/2"
191
TO 100° UP TO 60" UP TO 48"
6 +12 3 0
5
+9 2
-5
4 +4
1 -9
6" 152
TO 130° UP TO 60" UP TO 48"
6 +14 3 0
5
+10 2
-4
4 +5
1 -9
4-1/2"
114
TO 180° UP TO 54" UP TO 42"
5
+10
4 +5
Notes: Closer is shipped at 11 turns. Maximum of 26 turns of power adjustment screw. Refer to Page 6, Fig. 5 to determine proper closer siz e.
UH4061
UH4062
3 0
2
-5
-10/-11
INSTALLATION SEQUENCE
1. Select degree of opening and use dimensions shown to locate 4 holes
on frame face for closer body and 2 holes on door for forearm shoe.
2. Prepare door and frame for fasteners (See Preparation for Fasteners,
Page 2, Figure 2).
3. Before installing closer body, set spring power for closer using Power
Adjustment Chart above.
4. Install closer on frame (outside of door) with speed regulating valves
towards the hinge.
5. Disassemble forearm from main arm by removing forearm screw (See
Page 2, Figure 1). Fasten forearm shoe and forearm to door face.
6. Mount main arm onto closer pinion shaft, as illustrated. Secure with
main arm screw.
7. Reassemble arm. Adjust forearm length so that it will be perpendicular
(at a 90° angle) to the door face. Secure with forearm screw.
8. Adjust closer (See page 6) and install cover.
5-1/2"
(140 mm)
MAIN ARM INSTALLATION INSTRUCTIONS
TOP JAMB INSTALLATION
MODEL UH4061 or UH4062 INSTALLATION INSTRUCTIONS
999-30027
1-3/4" (44.5 mm)
2" (51 mm)
MAXIMUM