Instructions / Assembly

FOR CUSTOMER CARE CALL TOLL FREE 800-562-5625 or [e-mail]
PAGE 2
Components:
• It is recommended that the door be hung on ball bearing type hinges so door swings freely.
• A separate door stop (supplied by others) is recommended to prevent damage to the door closer, closer arm, the door, frame or adjacent walls.
• Door and frame must be properly reinforced or through bolts used to prevent the mounting screws from pulling out.
Figure 1
Figure 2
Fasteners Door or Frame Drill Sizes Where Used
Self Drilling/Tapping
Machine Screw
Hollow Metal or
Aluminum
3/16" Closer
1/4"-20 Machine Screw
Hollow Metal or
Aluminum
#7 (.201") Drill bit & 1/4"-20
Tap
Closer & Parallel Arm
(PA) Plate / Foot
Wood Screw Wood
5/32" Drill Bit – Softwood
3/16" Drill Bit – Hardwood
* Measure door thickness before drilling pilot holes to prevent drilling through opposite side
Closer & PA Plate / Foot
1/4"-20 Machine Screw
used with Through Bolt
Hollow Metal or
Aluminum
Wood
9/32" Drill Bit Closer Side &
3/8" Drill Bit Opposite Side
Closer
*Drill Depth
Through one side
5/8" – Closer
1/2" – PA Plate/Foot
1-1/4"
9/32" – Through Door
3/8" – 1/2"
Preparation for Fasteners
Latch Speed
Valve
Sweep Speed Valve
Backcheck Valve
Standard Closer
Mounting Plate
For mounting plate installation,
refer to supplemental installation sheet.
Closer Arm
Main Arm
Forearm
Forearm Screw
Forearm
Shoe
Forearm Shoe
Screw
Main Arm Screw
Plastic Cover
Through Bolt and Screw
Screw Package
Parallel Arm Plate