Installation Guide

ManualsBrandsUniversal Hardware ManualsDoor Hardware2-3/4 in. Aged Bronze Passage Commercial Standard Duty Hall/Closet Door Lever

UNIVERSAL

HARDWARE

The Professional’s Choice

NEW DOOR PREPARATION LATCH PREPARATION INSTALL LATCH

INSTALL INSIDE ROSE

INSTALL INSIDE KNOB/LEVER

INSTALL STRIKE

Fold template on edge of door and mark hole for 2-3/8" or 2-3/4" backset.

Drill 2-1/8" hole through door (from both sides to avoid damaging door).

Drill a 1" hole in edge of door.

CENTER LINE

BASE

2-1/8"

2-1/4"

1/8"

2-3/4"

2-3/8" OR

2-3/8"

2-3/4"

CAM

This latch comes pre-set for a 2-3/8" backset.

To change the latch for a 2-3/4" backset push the cam

toward the end of the latch.

Install as shown for appropriate latch type. Ensure bevel faces door jamb.

INSIDE

KNOB/

LEVER

Separate inside assembly.

Align cut with location tab and

push rose until it snaps into place.

Keep locking bar and turn button horizontal.

Push knob/lever until catch snaps into place.

Insert push pin into hole to

depress catch and remove lever.

Remove inside rose carefully

with a at head screwdriver.

LOCKING BAR

SPINDLE

OUTSIDE KNOB/LEVER

CAM

CATCH

After the door is closed,

guardbolt should be

retracted.

DOOR

STRIKE BOX

OPTIONAL

CENTER LINE

STRIKE

JAMB

INSTALLATION INSTRUCTIONS FOR TUBULAR KNOBSET/LEVERSET MODELS:

UH40047, UH40048, UH40049, UH40050, UH40051, UH40052, UH40053, UH40054 &

UH40057.

• Backset 2-3/8" or 2-3/4"• Fits Doors 1-3/8" to 2" Thick

DISASSEMBLE INSIDE KNOB/LEVER & INSIDE ROSE

INSTALL OUTSIDE KNOB/LEVER

INSTALL INSIDE ASSEMBLY

PLATE

TOWARD

DOOR EDGE

INSIDE ROSE

Unclip with

screwdriver

INSIDE KNOB/LEVER

KNOB/LEVER

Summary of content (2 pages)

PAGE 1
UNIVERSAL HARDWARE The Professional’s Choice INSTALLATION INSTRUCTIONS FOR TUBULAR KNOBSET/LEVERSET MODELS: UH40047, UH40048, UH40049, UH40050, UH40051, UH40052, UH40053, UH40054 & UH40057. • Fits Doors 1-3/8" to 2" Thick • Backset 2-3/8" or 2-3/4" BASE NEW DOOR PREPARATION A: INSTALL LATCH This latch comes pre-set for a 2-3/8" backset. Fold template on edge of door and mark hole for 2-3/8" or 2-3/4" backset. 2-1/8" Drill 2-1/8" hole through door (from both sides to avoid damaging door).
PAGE 2
UNIVERSAL HARDWARE The Professional’s Choice INSTRUCCIONES DE INSTALACIÓN PARA EL CONJUNTO DE PERILLA/MANIJA TUBULAR MODELOS: UH40047, UH40048, UH40049, UH40050, UH40051, UH40052, UH40053, UH40054 Y UH40057. • Para puertas con espesor de 28.50 mm a 50.8 mm (1-3/8" a 2") • Distancia del borde de la puerta al centro del cerrojo de 60.34 mm o 69.