User`s manual

15
5. Multi-Brand IR Remote Controller Setting
NOTE : When there is no input during about 10 seconds from set mode, set mode is
canceled.
1. Direct Code Entry
Step 1 : Turn on the DEVICE what you want to set up(TV / DVD / VCR)
Step 2 : Press DEVICE and OK button during about 2 seconds at the same time.
 DEVICE LED will blink twice.
Step 3 : Input the 3 digit code numbers.
(Refer to ‘Code Table for Universal Remote Control Unit’ in the rear section of this manual)
 DEVICE LED will blink twice and the DEVICE turns off.
 If you enter a wrong DEVICE code, DEVICE will blink once
Step 4 : If your DEVICE turns off, press OK button.
 DEVICE LED will blink twice.
2. Auto Code Search
Step 1 : Turn on the DEVICE what you want to set up(TV, DVD)
Step 2 : Press DEVICE and OK buttons during about 2 seconds at the same time.
 DEVICE LED will blink twice.
Step 3 : Press UP or Down button within 10 seconds to enter the Search mode.
Step 4 : Press UP or Down button until the DEVICE turns off, one and one.
Step 5 : If your DEVICE turns off, press OK button.
 DEVICE LED will blink twice.
3. Code No. Checking (Number Call)
Step 1 : Press DEVICE and OK buttons during about 2 seconds at the same time.
 DEVICE LED will blink twice.
Step 2 : Press INFO button within 3 seconds.
 LED will blink according to inputted mode number on the device.
( Case of digit '0', it blinks 10 times.)