User's Manual

ManualsBrandsUniversal Electronics ManualsElectronicsTPMC-4XG

Caring for TPMC-4XG

Use only the stylus or your finger to switch TPMC-4XG on or off. Avoid

using sharp objects. C

lean your controller with a soft, damp cloth using a

gentle, non-caustic cleaner

CAUTION: Do not use a caustic or abrasive cleaner. This may damage the

surface of your controller.

For more information, contact

your installer/integrator:

NOTICE: FCC NOTICE: This equipment has been tested and found to comply with the limits

for a class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed

to provide a reasonable protection against harmful interference in a residential installation.

This equipment generates, uses, and can radiate radio frequency energy if not installed and

used in accordance with the instructions, and may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and on, the user

is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and the receiver.

• Connect the equipment into an outlet or a circuit different from that to which the receiver is

connected.

• Consult the dealer or an experienced radio/TV technician for help.

Operation is subject to the following two conditions: (1) this device may not cause harmful

interference, and (2) this device must accept any interference received, including

interference that may cause undesired operation.

This equipment has been verified to comply with the limits for a class B computing device,

pursuant to FCC Rules. In order to maintain compliance with FCC regulations, shielded

cables must be used with this equipment. Operation with non-approved equipment or

unshielded cables is likely to result in interference to radio and TV reception.

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled

environment. In order to avoid the possibility of exceeding the FCC radio frequency exposure limits,

human’s body proximity to the device should not be less than 20 cm during normal operation.

WARNING: Changes or modifications of this equipment not expressly approved by the party

responsible for compliance could void the user’s authority to operate the equipment.

FCC ID: MG372400C

IC ID: 2575A-URC7240C

CAUTION: RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE.

DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS.

The socket-outlet shall be installed near the equipment and shall be easily accessible.

The equipment is to be supplied from an identified USB port complying with the

requirements of Limited Power Source.

Corporate Headquarters

Universal Electronics

6101 Gateway Drive

Cypress, CA 90630-4841

714-820-1000

www.uei.com

Installer/integrator: attach your

business card or business

sticker here.