User's Manual Part 1

www.urcsupport.com

To turn all nodes either on or off, perform the following

steps:

NOTE: If the red LED emits one long, steady blink, you

have pressed an invalid key or the All-On/All-Off

command was not successful. Repeat the steps

above to try again.

Adding Nodes to All Control

NOTE: If the red LED emits one long, steady blink, the

node has not been successfully added to the group.

Deleting Nodes from All Control

NOTE: If the red LED emits one long, steady blink,

the node has not been successfully added to

the group.

TRANSFERRING NODE AND NETWORK

INFORMATION TO A SECONDARY REMOTE

You can add a secondary remote to your network, and

transfer your primary remote’s node and network

information to it. To transfer node and network

information to a secondary remote, perform the

following steps:

1. Place the two remotes near each other.

2. Press HOME.

1. Press HOME once.

2. Press ALL once.

3. Press either ON to turn the nodes on, or OFF to

turn the nodes off. Any ON or OFF can be

pressed. The green LED blinks once.

1. Press HOME once.

1. Press ADD once.

2. Press ALL once. The red LED blinks rapidly.

3. Press the button on the node so that it sends

its information to the remote and receives

information from the remote.

4. The green LED blinks twice. The node has

been successfully added.

1. Press HOME once.

1. Press REMOVE once.

2. Press ALL once. The red LED blinks rapidly.

3. Press the button on the node so that it sends

its information to the remote and receives

information from the remote.

4. The green LED blinks twice. The node has

been successfully deleted.

Helix 5 Device.fm Page 26 Tuesday, June 5, 2007 5:24 PM