User's Manual Part 1

www.urcsupport.com
23
NOTE: Only one device can be assigned to an unused
device key at a time.
To re-assign another unused device key, substitute it for
the DVD/VCR key above and then perform the sequence.
For example, to re-assign an unused AMP key as a
second DVD key, perform
AMPÆSETUPÆ9Æ9Æ2ÆDVDÆAMP.
When a re-assignment is done, the selected device key
(e.g., AMP) will blink twice to confirm your choice. At
that time, you will need to program device control (see
“Programming Device Control” on page 9).
ADDING A NODE TO YOUR Z-WAVE NETWORK
The Helix Z-wave 5-Device Remote Control with
Learning allows you to control lights around your home.
In order to control the lights, they must be Z-wave
compatible and you must first add them to your home
network.
Adding a Node to the Network
To add a node to your home network, perform the
following steps:
NOTE: If the Home red LED emits one long, steady
blink, you have pressed an invalid key or the
node has not been successfully added the
To Re-Assign Perform Key Sequence
DVD/VCR as
2nd AMP key
DVD/
VCRÆSETUPÆ9Æ9Æ2ÆAMPÆDVD
/VCR
DVD/VCR as
2nd TV key
DVD/
VCRÆSETUPÆ9Æ9Æ2ÆTVÆDVD/
VCR
DVD/VCR as
2nd SAT key
DVD/
VCRÆSETUPÆ9Æ9Æ2ÆSATÆDVD/
VCR
DVD/VCR
back to VCR
DVD/VCRÆSETUPÆ9Æ9Æ2ÆDVD/
VCRÆDVD/VCR
1. Press HOME once.
2. Press and release ADD twice. The red LED
blinks rapidly.
3. Press the button on the node so that it sends
its information to the remote and receives
information from the remote.
4. The HOME LED blinks green twice.
Helix 5 Device.fm Page 23 Tuesday, June 5, 2007 5:24 PM