User's Manual Part 1

www.urcsupport.com
22
Clearing the Master Power Key
RE-ASSIGNING DEVICE KEYS
The Helix Z-wave 5-Device Remote Control with
Learning can be set up to control a second device of an
already-assigned type. For example, to have the unit
control a TV, a Cable Converter, and two audio devices
(for example, two audio receivers), re-assign the unused
DVD/VCR key to operate the second audio device as
follows:
NOTE: DVD/VCR is preset at the factory to control an
RCA DVD. Performing the steps below will
overwrite those settings.
The DVD/VCR key is now ready to be programmed for
your second audio device. See “Programming Device
Control” on page 9. To re-assign other device keys,
repeat these and substitute the key sequence using the
following chart:
1. On the remote control, press and hold SETUP
until the last-selected device key blinks twice.
2. Enter 9 9 5. The last-selected device key
blinks twice.
3. Press and release PWR.
4. Press and hold SETUP until the SAT key blinks
twice.
1. On the remote control, press DVD/VCR once; it
will blink once. Then press and hold SETUP
until the DVD/VCR key blinks twice.
2. Enter 9 9 2. The DVD/VCR key will blink
twice.
3. Press AMP once, then press DVD/VCR once.
The DVD/VCR key will blink twice.
Helix 5 Device.fm Page 22 Tuesday, June 5, 2007 5:24 PM