User's Manual

Viewsonic Tweety RF Remote Rev 2.9A November 05, 2001
Universal Electronics Inc. Confidential Page 55 of 63
8.2.4 Cosmetic Evaluation
Part must not be "pre-inspected" at a distance closer than that allowed in the Viewing Angle and
Distance criteria.
8.2.4.1 All Classes
General: Blush marks, burns, pits, pulling, short shot, silver-streaks, slay, and weldlines
are not acceptable.
Cleanliness: Part must be free of dust, oil, grime, grease, and other contaminants. Dust
caused by shipping material is acceptable if it can be blown off by air or wiped
off.
8.2.4.2 Class I- Acceptable Flaws table
Maximum Inspection Time: 10 seconds
Type Size Qty
Parting Line Flash 0.15mm 1
Key Opening Flash 0.05mm per opening
Mismatch 0.15mm 1
Scratches (within texture depth) 1.5x0.2mm 3
Contamination 0.5mm 4
Sink not allowed
8.2.4.3 Class II- Acceptable Flaws table
Maximum Inspection Time: 5 seconds
Type Size Qty
Parting Line Flash 0.15mm 1
Mismatch 0.15mm 1
Scratches 2.0x0.2x0.3mm 4
Contamination 0.8mm 4
Sink 0.2mm 2