Owner's Manual

25
1. Press
 and  (rewind and fast
forward) at the same time until the
power key blinks twice, then 995.
The power key blinks twice.
2. Press Power.
3. Enter the series of commands you
want the macro to execute (up to 8
commands).
4. Press OK to save the power macro.
Now, when you press and hold the Power
key for about 1.5 seconds, the remote
will send the series of commands you
have entered. For example, you could
program the Power key to turn on both
your TV and cable box and select a
particular channel.
Clearing the Power Macro
1. Press
 and  (rewind and fast
forward) at the same time until the
power key blinks twice, then 995.
The power key blinks twice.
2. Press Power.
3. Press OK to clear the power macro.
Now pressing and holding Power simply
turns the selected device on or off.
CLEARING CUSTOM
PROGRAMMING
The MediaRemote with SimpleCenter
contains a Custom Programming Reset
option. You can use it to remove all
custom programming except your setup
codes.
IMPORTANT: Executing this program will
erase all custom settings for
Volume Lock, Learned Keys,
Macros, and Channel Lock.
However, your device programming
remains.
NOTE: If more than 10 seconds pass
between key presses, the remote
exits programming.
1. Press
 and  (rewind and fast
forward) at the same time until the
power key blinks twice.
2. Enter 980. The power key blinks
twice, pauses, and blinks twice
again to confirm that all custom
programming is cleared.
Media Remote Rev 1.fm Page 25 Monday, October 3, 2005 4:12 PM