Owner's Manual

24
keys, which may contain a dif-
ferent macro for each device
mode)
• Activate a macro by pressing and
holding the key to which it is
assigned for at least 1.5 seconds.
Pressing a key for less time simply
performs the original function.
NOTE: If more than 10 seconds pass
between key presses, the remote
exits programming.
Creating a Macro
Y
ou can program a sequence of command s
onto a key that will execute only in a
specific mode.
1. Press the device key (TV, CBL/SAT,
or AUDIO) corresponding to the
mode where you want to execute
the macro.
2. Press
 and  (rewind and fast
forward) at the same time until the
power key blinks twice, then 995.
The power key blinks twice.
3. Press the key that will activate the
macro.
4. Enter a sequence of commands (up
to 32 keypresses).
5. Press OK to save the macro.
NOTE: If you program a macro onto a key
you’ve already used for a another
macro, the new macro will erase the
previous macro.
Clearing a Macro
To c le a r a ma c ro:
1. Press the device key (TV, CBL/SAT,
or AUDIO) where the macro is
stored.
2. Press
 and  (rewind and fast
forward) at the same time until the
power key blinks twice, then 995.
The power key blinks twice.
3. Press the key containing the macro
in the mode you selected.
4. Press OK to clear the macro.
Creating a Power Macro
You can use your new MediaRemote with
SimpleCenter to simply turn on a
particular device, or you can set up the
Power key to perform several actions:
Media Remote Rev 1.fm Page 24 Monday, October 3, 2005 4:12 PM