User Manual

7 Program Summary Tab
This tab shows the program names in a table form showing if it is enabled, the status, the type of
program, the last run time and the last finish time.
Figure 45. Program Summary screen.
The Name column contains the program names created in the Program Detail tab.
The Enable column defines whether the program is ON or OFF. When set to OFF, the program
is stopped from acting on any stimulus that starts the program. When set to ON, it allows the
program to act on the stimulus to start it.
The Activity column represents the program process. The program states are; Idle, Running
‘Then’ and Running ‘Else’. Idle state, is when the program is running and is waiting for the
stimulus to occur. It will also show Running ‘Then’ and Running ‘Else’ messages. These
messages are momentarily shown as the program enters and exits the Then or Else statements
within the program.
The Status column presents you with the program state. You will only be presented a True or
False state in the column.
The Path column shows the program location in the program detail tab. Refer to 8.
Last Run Time and Last Finish Time columns are a time log or time stamp of when the program
started and ended.